-
```c++
/*
RadioLib SX126x Transmit Example
This example transmits packets using SX1262 LoRa radio module.
Each packet contains up to 256 bytes of data, in the form of:
- Arduino Stri…
-
Found a problem with waking up the SX1261 chip.
In the sx1261mbxbas-board.c file of the void SX126xWakeup (void) function, you must add a delay of at least 100 μs after the ChipSelect signal.
`
voi…
-
I just didn't see Software Serial. h in the project. I guess it was uploaded or something. I compiled it using Arduino platform. Look forward to it. Thank you.
-
Hy @beegee-tokyo, i really enjoy your discussions in radiolib issues about ebyte module.
currently, i try to develop e22-900m30s ebyte module, as far as i know, your library and radiolib can apply …
-
Hey, i think i found a bug in SX126XLT.cpp
my Setup : Semtech SX1261MB2BAS Shield + Arduino Pro mini 3.3V 8Mhz
my Problem: the program stayed in DI01 checking loop forever.
`while (!digitalRea…
-
Length of SyncWord on SX126x radios is being set as a value in bits, which is solved in library simply by:
```c++
// update packet parameters
_syncWordLength = len * 8;
state = setPacketParamsFS…
-
This can be considered bug or feature, so I'll leave it as a general question.
Is there a reason why whitening on SX126x defaults to ON? This got me stuck for few days until I found it, now I'm fin…
-
In src/radio/sx126x/radio.c the function RadioRandom is documented to "disable all interrupts". It does not do that, however.
I compared the implementation with the one from the SX1276, which does …
-
To be honest, I highly recommend this function that can support modularity. For example, if you only need SMS, then the interface reminds you that you can only use this, and I hope that the APP of thi…
-
HI
I am debugging the SX1261 sleep mode on the board. When I remove the SX1261 from the hardware and the whole board current is 1.2ua, my stm32 sleep mode should be no problem.
So I would like t…