-
### Describe the bug
Attached is a Screenshot. On all Solarchargers connected to the Victron System,
I get spikes in the power-values when serialbattery is used.
I don't geht them if i do not use …
-
Hello,
I have the problem that when I want to install on my CerboGX I get an installation error.
```
ERROR: Command errored out with exit status 1:
command: /usr/bin/python /usr/lib/python…
-
The sensor worked when i install it then after couple of minutes it says, it's not connected. Can i check in someway if the sensor is there?
-
**Describe the bug**
During startup of serialbattery the values printed seems not to be correct. However, viewing cell voltage level via console seems to be right
**To Reproduce**
Use Jbd bms and…
-
Hi mr-manuel
Tried to use your backup script on a raspberryPi 3B using VenusOS 3.00-32
The backup breaks up in the middle and I assume, that the share cannot be mounted as the script cannot unmoun…
-
**Describe the bug**
after entering a custom device name (e.g. "Battery") in the GUI under /device/name and a reboot, the default device name (e.g. "SerialBattery(JKBMS)") is set again
**To Reprod…
-
**Describe the bug**
After finally (after some bumps) finishing the installation of Dbus SB I found that a sudden Grid feed-in of >4000w was taking place.
I just installed dbus-serial battery driv…
-
In VenusGX device in bigger installation, there are 5 pcs BMV-700 + 6 pcs MPPT BlueSolar /SmartSolar installed, by use of VE.direct -USB interfaces and active USB 3.0 HUB.
If JBD BMS with USB-RS48…
-
JK BMS looses connection after battery high voltage alarm.
**VenusOS
- Device ty…
-
Hello,
my Multiplus II keeps changing between charging and discharging at MAX_CELL_VOLTAGE = 3.45 (55.2)
Every 10 sec or so.
Is this a normal behavior, or did I miss any settings?
Versions:
…