-
my device is an RGBW with IR magic ligic home light version 2.3
configured to magic home
GPIO4 ->IRrecv
GPIO13 Led1i -> PWM4
i also did the ''command 15 1''
colors are not correct and i have …
-
On an irregular basis, domoticz crashes with a signal 6 message. Going through the forum, others seem to be affected by this as well although there doesn't seem to be an apparent cause.
```
Apr …
-
Flashed tasmota on H801.
Set the board type to H801 in web config.
But the only command it understands is PWM. Is that normal?
Have tried several combinations but all without any luck. Strangely e…
-
**IMPORTANT NOTICE**
If you do not complete the template below it is likely that your issue will not be addressed. When providing information about your issue please be as extensive as possible so th…
-
Wondering what bulbs people have tested from ali express and such places
ESP8266 based preferably.
-
I'm trying to flash an Arilux LED controller v1.4 board, but I can't get it to boot in flash mode. I have it connected up as follows (as per [this wiki page):](https://github.com/arendst/Sonoff-Tasmo…
-
**IMPORTANT NOTICE**
If you do not complete the template below it is likely that your issue will not be addressed. When providing information about your issue please be as extensive as possible so th…
rt400 updated
6 years ago
-
I have a bunch of these Magichome v2.3 boards now and a lot of RGBW strips of LEDs
The strips are alternating RGB LED and Warm White LED with the dedicated White on PWM4
The problem is that in Set…
-
Make sure these boxes are checked [x] before submitting your issue - Thank you!
- [x ] Searched the problem in issues (https://github.com/arendst/Sonoff-Tasmota/issues)
- [x ] Searched the problem…
-
Make sure these boxes are checked [x] before submitting your issue - Thank you!
- [X] Searched the problem in issues (https://github.com/arendst/Sonoff-Tasmota/issues)
- [X] Searched the problem i…