-
### Description
Folks, I implemented a plugin brush tool that shows segmentation of axial, coronal, and sagittal simultaneously.
This uses [cornerstone-side-image-loader](https://github.com/planta…
-
- What interfaces *must* be implemented by which subclasses (e.g. resampling, smoothing, slicing etc.?)
- Alternatively, unify everything in `SolutionBase` and make use of internal dimensions.
-
-
Develop functionality to create the geometry of the centrifugal compressor
- [ ] Inlet guide vanes (in the future)
- [x] Impeller/rotor
- [ ] Interspace gap
- [x] Diffuser/stator
- [x] Vaneless
…
-
Hi, in the V4 version, I saw the addition of axial induction control, also known as AWC mode, to control pitch angle. However, how can the yaw angle be controlled simultaneously in this…
-
### **THIS ISSUE IS OBSOLETE. THE CASE WILL BE KEPT FOR POSSIBLE FUTURE NEEDS.**
I have written an Octave script which compares turbinesFoam results to QBlade results.
Below is the case details:…
-
When running the reconstruction on two T2 scans (axial and coronal) I receive strange artefacts in the reconstruction. Do you have an idea what might cause these? The image on the top right is the axi…
-
When the image matrix is angled (i.e., far from just axial, coronal or sagittal), the origin and offset for each slice are not calculated correctly.
-
As mentioned in your paper:
"We take the dataset from the AAPM 2016 CT low-dose grand challenge, where the data are acquired in a fan-beam geometry with varying parameters, as presented in Table 4. …
-
1. You probably are going to change the window titles, right?
- [x] Quite a bit will change on the way to full release. Do you have good suggestions?
2. I want to suggest using QLabels instead …