-
* Brand: Märklin
* Model: m83
* Type: ACC
* Firmware: default
* Connector: screw terminal
* ACK Settings:
* Rating: 2/3
* Comments:
-
Issue Type: __Bug__
I have a new PR4. So far I am NOT thrilled.
I want to use it as a simple programmer on a separate programming track. It is connected properly as best I can tell. (comm4, …
-
*Sent by (dccextended@gmail.com). Created by [fire](https://fire.fundersclub.com/).*
---
## William created a ticket
Name: William Chandler
Email: dollarbillchandler@gmail.com
Timezone: -5
Soft…
-
*Sent by (dccextended@gmail.com). Created by [fire](https://fire.fundersclub.com/).*
---
## Tony created a ticket
Name: Tony
Email: abprosser@gmail.com
Timezone: 10
Software: CommandStationEX
…
-
```
rauc install http://10.0.0.10/bundles/update.raucb
installing
0% Installing
0% Determining slot states
20% Determining slot states done.
20% Checking bundle
20% Verifying signature
…
-
Issue Type: __Bug__
In JMRI 5.0 on Linux Mint 20.3 a running locomotive causes spontaneous sensor activation all over the layout -- also switching turnouts, perhaps as a consequence. Going back to …
-
I noticed that without a mask, a decVal definition will trim the number read/entered to 8 bits/1 byte, even if maxVal > 256. This results in eg 1000 replied by the decoder showing up as 233 in the pro…
-
Issue Type: __Bug__
I am using a Digitrax DCS 52 and anMacBook Air running Montery (12.1)
I have a Serial to USB converter cord - attached to a hub which attaches to the USB C port on my mac…
-
*Sent by robert franklin (f563gawiom@yahoo.co.uk). Created by [fire](https://fire.fundersclub.com/).*
---
Hi
Just gone from dcc ++ to EX
Using mega 2560 and Deek Robot motor shield
I done mySetu…
-
*Sent by Mark Bloomer (mark.bloomer@hotmail.co.uk). Created by [fire](https://fire.fundersclub.com/).*
---
Hi
I have created the base station and didn't get any errors when uploading or compili…