-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
I know the support to extui is no more provided since the first (and only one working) 2.0.6.…
-
**Describe the bug**
Repeated error message (perhaps) associated with segmentation fault (not captured but it was position out of loom):
`arvo: replacement event (for %hear) failed`
**To Reproduc…
-
### Disclaimers
- [X] I have searched the issue tracker to check if the issue has already been reported.
- [ ] My issue happened while using mods.
### What happened?
When using the submarine editor…
-
Hi,
I performed a Firmware upgrade of my Silicon Labs CP2102N (UZB-7) 700 series controller.
Ever since, all my nodes seem to be dead. Only when a report is triggered from the device, does it se…
-
https://github.com/dotnet/dotNext/blob/24b6f07def13e008a91c4f6455ba2b686d93cf77/src/DotNext/RandomExtensions.cs#L45
Using the remainder modulo the length will generate biased results when `(uint)al…
-
### Disclaimers
- [X] I have searched the issue tracker to check if the issue has already been reported.
- [ ] My issue happened while using mods.
### What happened?
When modifying the value of a m…
-
**Expected Result**
To be able to debug program crashes using `lldb`.
**Actual Result**
I get error messages when trying to launch the program in `lldb`.
**Steps To Reproduce**
```
Darling…
-
when i use serial RTU and RS-485 wires, how do i set set RTS high and low.
i know i gotta to do it in the source codes, like for read_holding_register request , i need to set it high to send the re…
-
The docker container prestosql/presto:337 contains numerous jar files that should not be needed. They should be removed from the container (and probably the rpm and tar.gz files as well).
Reasons f…
-
24th of March 2022
### Introduction
This document describes how to build and install Darling, a MacOS emulator for Linux, on OpenSUSE Leap 15.4 Beta. Darling can be considered to be the ‘Wine’ f…