-
### Version
Slic3rPE-1.42.0-alpha1+win64-full-201812231738
### Operating system type + version
Win10 x64
### Behavior
* _Describe the problem_
I can move part in X and Y direction with t…
-
Just power off both heater and bed :(((
Two different (mirrored) pcs at the same heigh.
Hardware: DUE+RAMPS-FD+LV8729 (XY) 8825 (Z+E)
Repetier, Marlin 2.0 works well
`/**
* MK4duo Firm…
-
First. let me appologize for the length of this post, but I feel this is a very important issue.
I have been doing some more testing to verify GRBL's running of g-code files. I decided to get a seria…
109JB updated
1 month ago
-
This isn't a problem, but rather a suggestion for a possible change. When a user wishes to change units from mm to inches, or the other way around, they have to accomplish 2 things. First a switch i…
109JB updated
9 years ago
-
the pid settings developed at madlab last week seem to have too little "umpf" for my machine. It never reaches the desired temperatures of M109 and waits forever.
-
I've written other embroidery input and output libraries for Python and Java. And considered this rather strongly over the years, ran into various problems with libembroidery itself and corrected them…
-
installed catboat via KIAUH, built firmware using the following params:
printer beeps 5…
-
The default PID parameters are assigned around https://github.com/Traumflug/Teacup_Firmware/blob/master/heater.c#L79 it might be nicer to move these out to config.h, or use some optional overrides li…
drf5n updated
8 years ago
-
Hey guys,
Just wanted to get this on the list for grbl mega. Not sure how this would be done but it would be nice to have the capability to do threading with a grbl controlled lathe.
If this shoul…
-
Good Morning all,
Would it be possible for someone to add a page to the Wiki that explains the correct way to wire NC limit switches. maybe with a schematic drawn up. I have been confused about this …