-
Using Continuous Jog with fluidnc , the laserGRBL only run unit table size 200x300mm, but the softlimits works well.
Is it a laserGRBL issue or must need make another configuration ? Or is not compat…
-
Hello,
I built a CoreXY laser machine and I am using Mega2560+RAMPS combo with grbl-Mega 1.1f. I have a problem with homing. Simply put after initiating homing, only one motor moves at a time. That m…
-
Hi Denvi
thanks for the candle code.
A while ago, I used the Candle on a 3018 machine with success. Now I have built a new CNC with UNO. Using GRBL commands in the serial monitor (Arduino IDE) I c…
-
I've got a project that is a sand table. The idea is a ball bearing is dragged through sand on a tabletop. This works fine, however, I want to send it 3d printer gcode files, where there are move rel…
-
This is on Debian 10.
It connects to the grbl 0.9j CNC, but it would not do any jogging.
`nick@cnc:~$ sudo pip install bCNC
Collecting bCNC
Requirement already satisfied: opencv-python==4.2.0.32…
-
Hi sir,
Good day, and I am so glad to have this change to report you this:
I got the latest Smoothieware firmware (using CNC mode) and try to make connection to board via telnet(port 23).
Once I …
-
Hello,
I have flashed a brand new tinybee with the firmware build on the webbuilder, config in lathe mode, no option, no wifi, nothing.
Just two motors, Z and X, no limits.
Reset params before te…
-
**What about adding a 'soft reset' command to GC?**
Working with the firmware non-Arduino boards, I've run into an issue - Arduino Mega boards do a hard reset when the serial connection is establi…
-
I just installed Candle 1.1.7, and I'm unable to get the jog to work properly.
I'm unable to move the stepper motors.
I can turn on the spindle however, but the steppers won't move.
When using Gr…
-
Tried many things. Here is what I get with my ramps board using grbl mega 5x:
![ramps](https://github.com/makerbase-mks/MKS-DLC32/assets/96264439/801f43ff-6e0d-494f-ad76-371b97ced0a2)
Using iden…