-
Hello,
### Subject of the issue
Unable to connect three IMU using SPI protocol
### Your workbench
* What platform are you using?
I use Arduino IDE to program the code.
* What version of…
-
Hello,
I try to reading motorbike tilt angle and I experiment a problem I also have with MPU-6050 in fact.
These chip seem to work well on desktop but using it on vehicle seem to be a challenge.
…
-
### Subject of the issue
Error in the image section of inv_icm20948_firmware_load
### Your workbench
Windows 11,
VS Code (1.62.3)
PlatformIO
with env:
platform = espressif32
board = node32s
…
-
How could i change the speed of SPI? I want to increase speed of spi to 7 MHz. How could I achieve it?
-
I have ther SparkFun OpenLog Artemis Redboard 9 DoF IMU.
This is my code below and actually with the settings I have implemented, I should achieve a sample rate of 560 Hz according to the data sheet…
-
### Subject of the issue
This library implements a mechanism to reduce the amount of I2C traffic by caching the previously used register bank and skip the bank change operation when it is not require…
-
### Subject of the issue
Unable to read compass
### Your workbench
* What platform are you using?
Arduino IDE to program code
* What version of the device are you using? Is there a firmware …
-
Just in case other users encounter the same problem, icm.beginSPI(cs_pin) works with Teensy 4.0, but not icm.beginSPI(cs_pin, sck_pin, etc). I suspect it's due to how the library tries to use port reg…
-
I'm using the C backend of this library on a raspberry pi. When compiling using arm-linux-gnueabihf-gcc the \_\_arm\_\_ macro is defined causing ICM_20948_C.c to attempt to include the avr/pgmspace.h …
-
Hello,
First, I must thank you for having created a great piece of hardware (SparkFun OpenLog Artemis) and firmware (OpenLog for Artemis). We have purchased about 10 boards and all of them work fla…