-
### The problem
Since this week (but may be much longer since I didn't use it for long until I create a new automation), controlling the Domestic Hot Water Mode of my OTGW is no longer working. I can…
-
### The problem
Upon a connection of the OpenTherm Gateway integration, the command PS=1 is issued, which retrieves all current values from the gateway.
If the gateway has just started, these values…
-
Hi, can someone give me datails about exact version of working 300w?
It seems that OpenTherm is not activated on mine :-(
Is it necessary to have the control panel connected on OT? Actually i have n…
-
### The problem
After upgrade from 2022.6.7 to 2022.9.0 i get the following error
Logger: homeassistant.config_entries
Source: components/opentherm_gw/__init__.py:442
First occurred: 10:55:52 PM…
-
### Feedback
It is quite unclear what to fill in for name, address and ID.
Ok, name seems to be used as a prefix for namingto the various entities -> please eplain that.
Address - what adress…
-
Hi, I am trying to use the DIYLESS gateway together with the example ino. Sadly I encounter numerous errors in and on missing libraries.
As I am searching the missing libraries and loading these "mi…
-
This may be a bit of an edge case...
My wiser system is only powered when the boiler is on, and the boiler is off when I'm not around.
That means that the logs fill with thousands of failed attempt…
-
### The problem
After the initial connect Opentherm Gateway disconnect and doesn‘t do anything any more. After Restarting the integration it works once an then stops again.
Ot-Monitor doesn‘t sh…
-
### The problem
Upon installing the Incomfort integration all entities exist twice in the system, once with a normal name, once with _2 in the name. Some examples:
```
water_heater.incomfort
wat…
-
Hi @wichers,
When compiling for ESPHome 2022.3.0 I'm getting the below errors about the binary sensor.
Any suggestions?
Thanks in advnce.
```
INFO Reading configuration /config/esphome/op…