-
![gpio_pi2](https://cloud.githubusercontent.com/assets/828293/7487407/2c1bc186-f3e1-11e4-91ad-575fc569055b.png)
source : http://www.element14.com/community/docs/DOC-73950/l/raspberry-pi-2-model-b-gpio…
-
Currently there are 2 different nodes to interface with the raspberry pi hardware (GPIO pins):
- [node-red-node-pi-gpio](https://flows.nodered.org/node/node-red-node-pi-gpio)
- [node-red-node-pi_g…
-
This sensor has an analog input signal going to the Raspberry Pi's GPIO pins. Since the Raspberry Pi doesn't have ADC, we need to use either an external MCU (like an Arduino) or the MCP3008 IC that wi…
-
Hi, thanks for the great project!
I set it up for my hardware and facing an issue: I need to control a fan.
The logic is the same as for the heater (apparently) because I connect it to a reversed …
-
### Describe the bug
For some reasons, `sensors` from lm-sensors package does not show `cpu_thermal-virtual-0` in OpenWRT with kernel-6.1, while it does on a standard Raspbian or Ubuntu setup on th…
-
### Script Command
```shell
sudo bash arcade-bonnet.sh
```
### Operating System
Raspberry Pi OS (64-bit) (debian bookworm) with raspberry pi desktop.
### Hardware
Raspberry Pi 5
…
-
Hello!
I am trying to get papertty-init to run on my Pi4,. I am using a fresh install of Raspberry Pi OS Lite and [this](https://www.amazon.com/dp/B07Z25LWTS) e-ink display. I have ran papertty-ini…
-
Upon Installing the legacy drivers (option '1' for 'weirdly square' 'no-touch' and rebooting. Display shows boot splash screen just fine, but at the desktop the image "scrolls" like a only CRT monitor…
-
I ordered this hat to power my pi 4 with PoE.
https://www.amazon.de/-/en/LoveRPi-Power-Over-Ethernet-Raspberry-Non-Insulated/dp/B07WD7HXSQ/ref=mp_s_a_1_14?dchild=1&keywords=raspberry+pi+4+poe+mütze&…
mumia updated
3 years ago
-
The PI-2230-SSD is an SSD expansion board specifically designed for the Raspberry PI 5 to provide PCIe to M.2 NVMe SSD function. The expansion board is designed based on the Raspberry PI official act…