-
I have noticed that currently this board does not appear to be able to handle SD cards that are 8GB or bigger.
I can use the 8GB card to upgrade Marlin, but past this point the SD card does not ini…
-
When the print starts, the temps climb properly. Once the print is finished, the temp indicators stay at print temperatures event though the bed and extruder are cooling down. After a print, even wh…
-
Hello,
I have a problem with the part cooling fan. It won't start or update the speed until one enters and exits various menus.
If I pushes the knob to enter the menu during the print, the fan s…
-
When using Marlin 2.0.4.4 as the source, compiling fails with the provided configuration files here in the repository.
Error message in vs code:
In file included from Marlin/src/HAL/HAL_STM32F1/..…
-
# SKR E3 mini V2.0 CNC Fans always on
I have just finished wiring my SKR E3 mini V2.0 and my part-cooling fan and motherboard-case are constantly on. I have reconnected the fans in both on the mother…
bazfp updated
3 years ago
-
I uploaded the new firmware onto the board and the firmware onto the TFT3.5 installed the com-port.
The board shows up as a USB drive as well, which is probably the issue and it's blocking the TFT3…
-
### Description
I Installed an BTT SKR MINI E3 V1.2 and the BL on a Ender 3 but when I try to do a Z Homing the Z axis is far apart from the bed and the BLT activate 3 times, and then appear a M9…
-
Hello community,
I have a SKR mini E3 v1.2, and I've been extremely satisfied with it! However, 2 days past I uploaded the new firmware.bin (supplied from bigtreetech over here) to my ender 3 and o…
Ciss0 updated
4 years ago
-
There is a problem in the [readme.md](https://github.com/bigtreetech/BIGTREETECH-SKR-mini-E3/tree/master/firmware/V1.0) for the point:
_After opening the project, go to the platformio.ini file and c…
-
The firmware from 9/1 is about 10k smaller than the previous compile and doesn't appear to have any BL Touch options in the menus.