-
I identify some issues not allowing to run tests on my host environment.
1. Target not stopping in plo
```
Flashing an image to device...
Done!
phoenix-rtos-tests/initfini/main: FAIL
PLO ERROR: …
-
### Description / Steps to reproduce the issue
The "nucleo-l432kc:nsh" config does not work out of the box since a few months. As of today, it still does not work.
Symptoms: NuttX NSH is capable o…
-
### Description of defect
CAN driver doesn't properly report errors. It always returns 1 as the write was successful, then turns out it wasn't
and errors are accumulated (not sure what the…
-
I am using env on linux.
On rt-thread v5.1.0 building for stm32l4 works. On the current git building for stm32l4 does not work.
Also, rt-thread/bsp/stm32/libraries/STM32L4xx_HAL is missing.
On 5…
-
Dear all,
I'm currently testing Espruino on a Linux box. On that configuration, from the moment a client socket is open and starts receiving data, the cpu load goes up to 100%. I quick look at the C …
-
There is one bigger and two minor thingies here but idk if creating 3 separate issues is a good thing in this case.
So I'm implementing DDR mode where data is sent on both clock edges. Unfortunatel…
-
If anyone would like to help build this up for a release please comment in this issue thread.
Todo:
- add more boards
- add documentation
- add wrapper library for FreeRTOS
~~add github ac…
-
I use a Nucleo-L476RG (STM32L76RG, Cortex-M4). I use libtrace to activate SWO UART output at 2Mhz (80MHz CPU speed), periodic PC sampling every 64 clock cycles, TPIU formatter off etc in the firmware …
-
Hi,
I see sometimes this ASSERT, is there a way to recover when it happens and understand when this could happen ?
Thanks
-
## Environment
- Module or chip used: ESP32-PICO-D4
- IDF version: v4.0-dev-771-gc9bf3a3b1
## Problem Description
The flush_uarts() function within components/esp32/sleep_modes.c does not h…