-
Hello
I am trying to update to the last version, i have tried with both versions 1.1.9 and 2.0, and my probe does not stop at homing.
Z_min is below bed level and I use the z_probe as Z_homing.
…
-
i tried to Print Multi Coulor (E.G White Black Blue) Throu Singelnozzle Diamond Head. Butttt... My Firm is Changing different Temperature and all everything it have to do to Print other extruder but t…
-
Hi
I have recently got printrun. However, it does not connect to the printer with a marlin firmware installed on a clone of Arduino Mega. What should I do? I run it obviously with sudo pronterface.py…
-
Hej Guys.
I have compiled the 1.1.9 marlin to my corexy printer, and i have the probe sat at 30mm(-30) to the left of the nozzle. My bed size is x175 y165 (z242)mm when i do the G28 and G29 with th…
-
You guys are always so helpful and have taught me so much already, but I keep discovering new issues with my firmware. After updating my firmware to the latest 2.0.4.3 bilinear autolevel fails at the …
-
I have a question about the molex connector on the Generac generators. I'm working on designing a small PCB that would plug into the GPIO connectors of the Raspberry Pi. For me, this started from a …
-
Felicity is reporting problems with her temperature sensor:
> ERROR - STOPPED
> Temp sensor
> Go to:
> ultimaker.com/ER01
That [error page](https://ultimaker.com/en/resources/19484-stopped-te…
-
```
Marlin/src/lcd/menu/menu_delta_calibrate.cpp: In function 'void _man_probe_pt(const float&, const float&)':
Marlin/src/lcd/menu/menu_delta_calibrate.cpp:42:76: error: 'DEFAULT_XYZ_STEPS_PER_UNIT…
-
Using Debian Buster, Marlin at commit c28e08c8, running an SKR v1.3 with a brand new RRD 12864 display (BigTreeTech red PCB model with contrast pot, via normal cables that needed no twisting/flipping/…
-
1. do not insert sd card
2. slow lcd respond with 0.5 sec for each line refresh
3. insert sd card
4. it become normal operation
5. take out sd card again
6. slow lcd repsond again ...
Regards
…