-
Hi Eric
I saw your module introduction, on the Octoprint discussion group, and I think I have a idea for you. As this would probably be easy for you to implement.
Would it be possible for you to a…
-
After a few days, the Leds stopps.
`------------------------22/12/28 15:32:01------------------------
pironman version: 1.2.3
username: pi
config_file: /home/pi/.config/pironman/config.txt
22/…
-
I believe that the `test` program compiled from `main.c` doesn't support the use of Channel 1, due to the following hardcoded values:
```
ws2811_t ledstring =
{
.freq = TARGET_FREQ,
.dm…
combs updated
3 years ago
-
I've been trying to run this on a Pi Zero W. I'm calling `render()` in a `setInterval(..., 1000/40)` loop. It usually works for a few seconds and then hangs and locks up somewhere in the middle of the…
-
Done in #11
-
Without sudo I get on Rapsberry Pi 3b+ an error like this:
Can't open /dev/mem: Operation not permitted.
Any safe solutions?
Thanks!
-
https://github.com/jgarff/rpi_ws281x/blob/ba3b5bdad55dc7754567a68c4364b1e772735f47/ws2811.c#L370
Are you sure that is the right DREQ/PANIC level configuration ? The PWM is an output peripheral, so …
-
Hello, trying to see if this wrapper is still alive. I see it hasn't been updated in quite a while and it's pretty far behind https://github.com/kenssamson/rpi-ws281x-csharp, but I figured I'd ask her…
-
I originally raised this issue against another project: https://github.com/jamesbulpin/meshblu-connector-ws2811/issues/4 However after some further investigation it appear the issue is rooted in this …
-
I'm trying to run this on Ras Pi OS lite on a PI Zero. I keep getting the error: no module named 'scipy'. Please help 😅