-
Create an overview of power consumption.
Should include:
- Draw when Idle
- Draw when max computation
- Draw when transmitting
- Draw when recieving
- Estimated lifetime in all modes
-
Subscribe to this issue and stay notified about new [daily trending repos in c](https://github.com/trending/c?since=daily).
-
**Describe the bug**
I have an Elivco plug with power meter.
I have installed the OpenBK7231T/OpenBeken release 1.17.136,
The plug has a small board with a BL602 and a BL0937 in a bigger board to g…
-
I have changed 0.0.0.0 to 192.168.200.239 but it's still using the old dhcp address.
The device have been swithed off but still the same problem.
Flags: 1120
**Firmware:**
- Version 1.17.494
- …
-
All the time Wi-Fi signal strength is shown like -1 dBm (excellent). This cannot be, because the Wi-Fi module is located at a distance from the router (5-10 meters). This signal strength is displayed …
-
When I try to use Home Assistant Discovery feature, I get this error in the log.
Chipset: BL602 (RGBCW Bulb)
Flags: 10, 37
Version: 1.15.633
1 drivers active (BP5758D), total 13
**To Reprodu…
ataa updated
10 months ago
-
It looks like the bl602 exclusively used sdu as an SDIO2 slave interface. However `bl616_sdu.c` in the SDK looks like a stub when compared with the [bl_iot_sdk_matter](https://github.com/bouffalolab/b…
-
The OpenBL602 image is too big to send OTA to the Sonoff B05-BL-A19 bulb.
First I am not even sure it can be upgraded using the OTA. The Sonoff website says it can but I haven't tried it since I ha…
-
Hi.
I purchased BHT-002-GCLW and I have a problem communicating with it.
```
tomik67@tomik67MINT ~ $ esptool -p /dev/ttyUSB0 -b 460800 read_flash 0x00000 0x100000 originalFirmware1M.bin
esptool.…
-
Using [this svd](https://github.com/sipeed/bl602-pac/blob/main/soc602_reg.svd) and svd2rust version 0.31.2, 0.31.3, or 0.31.4 generates a PAC that fails to build.
0.31.1 and 0.30.3 do generate a PAC …