-
Hi can you calculate from the gas resistance value o justa get the IAQ and Accuracy status? Thanks
-
Hi Robert,
I would like to see VOC calculation added to the these drivers. I would like to use this issue to discuss calibration and calculation.
Yesterday, the Extech VFM200 arrived, so I gave it…
-
I share you my logfiles after flash.
I think i have here a problem:
"[17:26:23][W][nextion:446]: Nextion reported Serial Buffer overflow!"
------------------------------------------------------…
-
### Describe the bug
(firmware/boot/overlays/README line 710, Name: apds9960) documents a param 'noints' which 'disables the interrupt GPIO line'. Therefore in boot/config.txt I have a line 'dtover…
-
I need to make CO2 measurements for 10 diffrent spots and found your project.
Thx you. I integrate it and try to test it.
It's running, but when I compare the Temperature and Humidity Value, they a…
-
We have an implementation of MiniMQTT that has been quite stable in CircuitPython 8 but started to display multiple issues when we tested in CircuitPython 9 (9.0.3 and below) on multiple ESP32-S3 boar…
-
I'm seeing a strange problem with the Full Duplex SPI library I can't figure out. Any help is appreciated!
The LSB on my reads usually comes back flipped even though my oscilloscope shows the slave…
-
Idea is to have a ESPHome node with three task areas.
#### 1. Plant monitoring
- [ ] Soil moisture
- [ ] Soil temperature
- [ ] Soil conductivity
- [ ] Water level of the flower box water res…
-
we can provide testing for these i2c components.
-
We have an environmental test setup here with several BME680s attached via a TCA9548A. On rare occasions when attempting to read a BME680, we can see _perform_reading() getting stuck in the loop shown…