-
Target device: Lenovo duet 4gb, 64 disk
Starting device: NixOS 22.05 x86_64
Hello, thanks for your work.
I'm trying to install mobile-nixos in my fresh new Lenovo Duet (4gb ram, 64 disk) but I'…
-
### What version of Music Assistant has the issue?
2.0.0b32
### The problem
When I try to connect squeezebox players with MAS, the players ate discovered by MAS but connection does not take p…
-
Should be a minor regression, noticed on 3.1.1 but could be earlier.
Whenever I do PID autotune, like `M303 H1 S250` it seems to complete successfully, but issuing `M303` afterwards always says `Heat…
-
### Duet Forum Discussion Thread
https://forum.duet3d.com/topic/29091/consistent-issue-with-m584-duet-3-mini-5/18
### Which Duet products are you using?
- [ ] Duet2-Wifi
- [ ] Duet2-Ethernet…
-
I have a Duet 0.85 that sets incorrect extrusion speed after certain commands.
I have been informed that this is reproducable on Duet 0.6, wifi, ethernet and Maestro boards and quote below what I w…
-
FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 3.4.1 ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2022-06-01 21:05:38
When i try to install ReleaseMgr 1.1.17 i get …
-
### Duet Forum Discussion Thread
https://forum.duet3d.com/topic/26109/meshbed-issues-corexy-ffw3?_=1637910482145
### Which Duet products are you using?
- [ ] Duet2-Wifi
- [ ] Duet2-Ethernet
- [ ] D…
-
I'm using a Laser filament sensor on E0 with a filament switch. When there's no filament present in E0 I cannot print with another extruder (E1), but I get an error 'Extruder 0 reports no filament'
…
-
### What version of Music Assistant has the issue?
2.0.0b30
### The problem
I operate a system with both airplay devices and Logitech squeezebox devices. So I have activated both the airplay …
-
# System
Board
Duet 3 Mini 5+ (Mini5plus)
DSF Version
3.3-rc2
Firmware
RepRapFirmware for Duet 3 Mini 5+ 3.3RC2 (…