-
Hi !
I'm trying to test your shady but I'm getting errors when compiling:
`
pi@raspberrypi:~ $ go get -u github.com/polyfloyd/shady/cmd/shady
# github.com/polyfloyd/shady/renderer
go/src/githu…
-
Does using the Active3 header for the raspberry pi eliminate the need for the Adafruit one if you don't want to try and hack it for the 64x64 led matrix?
-
Hi I bought 2 of these devices cheap as chips off ebay. V2.3 with no RX/TX pads and no IR connected.
I flashed one of them with the latest tasmota build using esptool (via raspi with serialUSB), mak…
-
I have had a quick look at some 64x64 P2.5 panels and discovered there is an additional decode line 'E' on the HUB75 interface. This is pin 8, which is currently pulled to ground on the Raspberry Pi …
-
Hi,
I connected one of my two 32x16 panels with the ElectroDragon board linked on the adapter page.
My panel has `P10-4S-3535-3216-JA1` printed on the back. The connectors are labeled with `HUB75D…
-
Dear Luc,
I have cloned your code (master branch) with the aim of using/tuning it to run on a smoothieboard variant (the AZSMZ mini) which has room reserved for an ESP01 module on its LCD board. I ha…
-
ESP32 (ESP-WROOM-32 dev board) sometimes it receives data but after some time it stops while transmission operates in the same application all the time.
I checked connections on different pins ...
T…
-
Hello,
I have a problem with output on 64x32 P5 8S RGB panel:
Configuration:
…
-
Hello,
I'm using an electrodragon in shutter mode and I've added a third output that is a "pwm" directly connected to the buit-in led of the electrodragon. Then, by using rules, I've linked the di…
-
Please take a few minutes to complete the requested information below. Our ability to provide assistance is greatly hampered without it. The details requested potenti…