-
There is currently no space in the specification for a few bits of (potentially) important information which will be obtained from other vessels over AIS. Here's a list with suggested modifications to…
-
### Description
with latest project from 29.12.2020:
First i am starting in TouchUI mode. All is working. I switch to MarlinUI and also all is working properly. If i switch back to TouchUI it´s no…
-
When I wannerization with wannier90.x file and then I got this error. Does it relate to number of Kmesh or number of nbands?
wann_main: problem computing schur form 1
srun: Job step aborted: Wa…
-
## Current status
Initial support of S0ix is available for testing; see https://github.com/QubesOS/qubes-issues/issues/6411#issuecomment-2089227397.
-----
***Editor's note:** The original iss…
-
My cover devices are not reflecting the correct 'state' in relation to their position. Is this controlled/managed in your scripts/discovery? I think HA flipped this recently?
I use window w…
-
Hello everybody,I have a problem with my delta printer and I would be very grateful if you help me
to solve it.
I'm using Arduino due + RADDS with Repetier firmware.
The problem started when the …
mj996 updated
4 years ago
-
### Describe the bug
In below system, when I set the scf_thr to 1e-14, the SCF will throw the error:
```
j = 9 lagrange norm = 1.120e-03
j = 10 lagrange norm = 2.589e-01
j = 11 lagrange norm = 1.…
-
### Type of Issue (Enhancement, Error, Bug, Question)
Question
----------------------------------------
#### Operating System
ALL
#### PySimpleGUI Port (tkinter, Qt, Wx, Web)
ALL
--…
-
I have noticed that if a drive dies during a wipe, nwipe won't notice until after it finishes "writing" the disk full.
This results in one of two failure behaviors.
The first is a super slow wipe. T…
-
as the title states.
please only use this thread for questions and discussion and open new feature requests for actual issues with OpenCNCPilot.
Martin