-
Hy,
how does the M204 go in SET_VELOCITY_LIMIT?
Did I understand correctly that the M204 GCode command must be changed by a PostScript to the SET_VELOCITY_LIMIT command?
does anyone have a script…
-
Hi!
First off, I just want to thank you for creating this awesome project, I really appreciate it!
But unfortunately I have run into an issue.
I am using the GcodeCNCDemo4AxisCNCShield with Ardui…
-
-
I usually control stepper motors. These seem to be missing in Wokwi. I can see a few challenges to implement them
1: Visual apperance - Similar to the Servo, with a shaft where the angular position…
-
gcode created with FreeCAD consisting of G2/G3 lines with big I an J parameters,
## This is what I expected to happen:
loading the gcode with linuxcnc should show the shape of the drawing…
-
It seems that my heater is not powerful enough to heat my extruder to the desired temperature anymore. Either it is degrading or the room-temperature dropped since I last printed 1 day earlier.
It…
-
luc Hi!
I am used ESP3d v 3.0 with SD card.
- MCU: ESP32
- Name: ESP32 Devkit v4
- Flash size: 4M
I connected the sd reader to the esp32 to contacts
CS D5
SCLK D17
MISO D19
MOSI D2…
-
Hi,
I am trying to create a new host module for a stepper motor axis that is synchronized to the kinematics movement. I am trying to create this with minimal changes to the main klippy modules. I hav…
-
/*
To replicate the problem use this Configuration.h
//Error description:
I want to use the marlin firmware to control three steppers without temperature sensors an extruders for my project which is …
-
Hi,
I am thinking about a little project, and I would like to hear the opinion of some experienced klipper user.
I would like to "port" the software you have made for the MCUs for machinekit.
M…
mngr0 updated
2 years ago