-
```
The EX-106 servo has a range of 12-bits, rather than 10, we need to do the
following:
# Allow PyPose to go up to 4095 for EX servos
# Select which servos are EX
# Adjust the radToServo() function…
-
```
What steps will reproduce the problem?
1. Build PhantomX Hexapod.
2. Load PyPose and run the "NUKE editor".
3. Assign servos to the labeled locations.
4. Capture limits and neutral poses.
To e…
-
```
Auto-save prompt is needed on the following:
1. sequence editing
2. sequence creation
3. pose creation
```
Original issue reported on code.google.com by `MFergs7@gmail.com` on 3 Apr 2011 at 1:53
-
```
What steps will reproduce the problem?
1. Create a new pose
2. Give it a blank name
What is the expected output? What do you see instead?
Warning message should probably pop up, instead, all hell…
-
```
As soon as we click Settings|Configuration we lose the current port selection.
If a port opening fails, the error message is not correctly carried to the
user.
```
Original issue reported on co…
-
```
What steps will reproduce the problem?
1. Build PhantomX Hexapod.
2. Load PyPose and run the "NUKE editor".
3. Assign servos to the labeled locations.
4. Capture limits and neutral poses.
To e…
-
```
Auto-save prompt is needed on the following:
1. sequence editing
2. sequence creation
3. pose creation
```
Original issue reported on code.google.com by `MFergs7@gmail.com` on 3 Apr 2011 at 1:53
-
```
What steps will reproduce the problem?
1. Create a new pose
2. Give it a blank name
What is the expected output? What do you see instead?
Warning message should probably pop up, instead, all hell…
-
```
As soon as we click Settings|Configuration we lose the current port selection.
If a port opening fails, the error message is not correctly carried to the
user.
```
Original issue reported on co…
-
```
i have aproblem with starting pypose
i download python2.7,wxpython2.9 and pyserial
i install them when i try to start pypose i had this message
Traceback (most recent call last):
File "C:\Users\a…