-
I'm going to build "vertical plotter", and want to make it WiFi way (ESP8266).
Did not found yet project what already did it.
Your firmware with **gcode** looks more usefull and promising then "…
eimix updated
6 years ago
-
Numerous mono applications are crashing or having errors with the following terminal output:
~~~
Could not set X locale modifiers
~~~
The issue can usually be resolved by running this in a te…
-
When i try to connect to my repetier, i'll get always this error.
Using Cura 5.0 release and Repetierintegration from today ( 64a68f0 )
Errormessage:
Traceback (most recent call last):
Fil…
G4Cab updated
2 years ago
-
IO brooker schaltet die Insatz ab da sie sich in einem restartloop befindet
repetierserver.0 | 2022-01-14 19:20:03.002 | warn | Read-only state "repetierserver.0.info.connection" has been w…
-
Hi. Amy way of altering the start and end codes for slicing.
I normally use repetier host for slicing but I have the new 3.5 tft and want to generate toolpath codes so I can have preview on the t…
-
Hello, I found another bug because of which you cannot start printing again
The reason of this bug is not clear, but it appears in several versions 1.04
It is possible to experience the bug even aft…
-
I will add platformIO support - it should allow to patch the due source automaticaly and so no need to do any manual changes
also it should allow to not change anything in configuration.h but use sp…
-
Hi,
I always have the problem when connecting that he says that the ip is not correct because it has a "." should have. but the ip is completely normal without "." written. I also uploaded the logs i…
-
I'm testing the dev2 repetier on one of our custom cartesian printers, with bare due electronics connected to octoprint on a pi.
Unfortunately when the v2 firmware is uploaded to the due, there is…
-
I have everything working normally using repetier host 0.82b and repetier firmware 0.71 on Generation 6 electronics..... except one problem... If I use the flowrate at all, even a small amount, my X a…