-
```
What steps will reproduce the problem?
1. crius i2c Nav v 1.1 want communicat
What is the expected output? What do you see instead?
in multiwiiConf i get i2c error's from -thousand to +thousand…
-
Hi,
I program the XPLR module from the Arduino IDE I received this message
do you know how to fix that?
17:00:14.256 ->
17:00:14.256 -> rst:0xc (SW_CPU_RESET),boot:0x33 (SPI_FAST_FLASH_BOOT)
…
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…
-
### Hardware used
MKR GSM 1400 with MKR GPS attached as a shield.
### Issue description
When using the MKR GPS example sketch, GPS data immediately appears in the serial monitor.
However, when…
-
Hello,
My device is zed_f9p and the yaml file is below
> `debug: 1
>
> device: /dev/ttyACM0
> frame_id: gps
> raw_data: true
>
> uart1:
> baudrate: 38400
> clear_bbr: true
> config_on…
-
As defined in the AT command manual, we use this table to blink the number of bars of signal strength when the MODE button is pressed once https://docs.particle.io/reference/changelog/#check-signal-st…
-
I just ran the Build-a-Pi Update-Tool on my 32-bit Pi3B+ and it broke my UBlox GPS clock sync.
There is a bug in the latest release of Debian that affects the Pi.
The /usr/lib/udev/rules.d/60-ser…
-
### Subject of the issue
PointPerfect for RTK Express Plus Support
https://docs.sparkfun.com/SparkFun_RTK_Firmware/configure_pointperfect/
### Your workbench
Dev 3.5 with express working as…