-
The Prusa Mini+ Buddy board ships with a bootloader pre-flashed at the factory.
When compiling the firmware source code from this repository, the bootloader is downloaded in binary form by `utils/b…
-
When I follow the WIKI
[https://github.com/AlkaMotors/AM32-MultiRotor-ESC-firmware/wiki/Flashing-Tekko32-45A-Single-ESC](url)
to flush the bootloader, I ran into the following problems:
1.Add th…
-
Following those [(link)](https://github.com/anmaped/openfang/blob/master/doc/SXJ02ZM/SXJ02ZM_instructions.md) instructions, where can I get pre-compiled 64M image?
In meantime I have successfully c…
-
Hey! So I'm just about to finish the installation of the latest version of Apricity and I got this error:
Boost.Python error in job "bootloader".
Command 'grub-install --target=i386-pc --recheck --f…
ghost updated
6 years ago
-
The WF32 web page is down (https://reference.digilentinc.com/reference/microprocessor/wf32/start) and I couldn't find the bootloader hex file anywhere. Can you upload the hex file?
Thank you
-
I've recently purchased and recieved my pico, and I've believe I set it up right; put it in bootloader mode, downloaded the uf2 file and downloaded thonny. However, every time I try to run code on it …
-
Hi.
Discipline is a great keyboard, I tried to make my own, but I encountered a little problem when flashing the boot loader, when I try to use qmk msys to make the hex file of the boot loader, an er…
-
Like in #1. Is necessary to modify the GPIO init and delete the unnecessary transceivers.
-
We should build a generic bootloader, that later will probably be replaced by a secure bootloader in a minion.
But for now it should follow the following precedence:
- Check a specific address on an …
-
I am trying to load the bootloader to cc1352, if I erase completely with uniflash I can program the new firmware, but once with the new firmware I can't reload other firmware
Thanks