-
Hello,
I'm using an electrodragon in shutter mode and I've added a third output that is a "pwm" directly connected to the buit-in led of the electrodragon. Then, by using rules, I've linked the di…
-
Please take a few minutes to complete the requested information below. Our ability to provide assistance is greatly hampered without it. The details requested potenti…
-
There is a new display in the i3 Mega S built in. Seems it is the same display like the one which is used in the Anycubic Mega X.
The special menu is not shown anymore.
-
Just got a Pi4 in and am wondering if anyone's had a chance to try it out w/ this lib? Seems that basic demos that run well on the 3b+ are rendered with noise:
Swap out this setup for a 3b+ and it'…
-
Dear all,
I've a issue by displaying "forward scrolling an image" on my led matrix 32x16 with a RGB Matrix Panel Drive Board For Raspberry Pi (provided by electrodragon) using pi3 .
During the test…
ghost updated
5 years ago
-
On the BC26 platform, the referenced core is `bc66`:
https://github.com/Wiz-IO/platform-quectel/blob/207b87a64285f66ea6ccdc6f9e050210e8255044/boards/bc26.json#L5
I came here while investigating av…
-
I successfully flashed one Electrodragon and some Sonoff Dual R1 boards with ESPurna 1.12.6.
I also flashed two R2 boards with 1.12.6 and of course changed the configuration in arduino.h to the r2 se…
-
**IMPORTANT NOTICE**
If you do not complete the template below it is likely that your issue will not be addressed. When providing information about your issue please be as extensive as possible so th…
-
### PROBLEM DESCRIPTION
In Tasmota the H801 controller flahes LEDS attached, briefly at full brilliance on powerup.
### REQUESTED INFORMATION
_Make sure your have performed every step and c…
-
Hi!
First of all I want to express words of appreciation for the hard work put into this project.
I have problem with connecting my iPhone to accessory. Apparently everything is fine, gets the…