-
Hi! I am working on an embedded project that would greatly benefit from using python for embedded sensors instead of C++ or Arduino. I have used the Micropython firmware on the ESP8266 platform and wo…
ghost updated
6 years ago
-
hello @CongducPham Sir ,
I'm currently working on a transmitter and reciever program for LoRa development Kit.
I'm trying to upload the following sketch on my LoRa development kit(http://ethicstech…
-
Hi. I am struggling to use ENC28J60 module with Adafruit Feather M0 board (ATSAMD21G18). Should I change any configuration in enc28j60network.h file for this board?. Any kind of help is appreciated.
…
-
I am totally stumped as to why I'm unable to get this module to work with a M0. I can take the same module move it back to Arduino Uno and it works fine. I'm using the standard example and changi…
-
Hi
I am trying to make this library work with the RAK811 module, but I can not find the correct configuration, I think my problem is in the definition and use of the pins
RADIO_RF_CRX_RX …
-
how to check whether lora Ra01 ai thinker working or not
-
Has anyone tried to decode signals from a LoRaWAN network, like the TTN, with this plugin?
LoRaWAN (with a few exceptions) uses the 125 kHz bandwidth, coding rate 5/6, explicit header, CRC on, SF var…
-
I had a problem with a hang when waiting for a large number of osticks (100 ms worth) running on the Feather M0 LoRa with the MCCI 1.0.4 BSP.
Investigation with prints() revealed that os_getTime() …
-
Hello
I saw a connection between io2 to pin 5 and io1 to 6. Why these connections are used?
Can i use other pins not 5 & 6?
Thank you very much for your kind help
ELI
ELIVB updated
6 years ago
-
Hello, it's really nice of your clear instruction and code that makes it easy to test with the adafruit feather m0 lora boards.
Just a quick question in your code: I am not sure how you set the fre…