-
**Bug description**
*A clear and concise description of what the bug is. Mention which EMS-ESP version you're using.*
after update to HA core version "core-2021.4.0" and supervisor to version "sup…
-
**Bug description**
My Bosch GC7000iW 35 C 23, is not setting warm active to on
directly it responds with an error
**Steps to reproduce**
logon to telnet and calling the command
call boiler…
-
**Describe the bug**
The configured port-number:8086 is already used by 'InfluxDB' at Homeassistant
**To Reproduce**
Steps to reproduce the behavior:
If the httpserver-daemon ~/HT3/sw/etc/html/h…
-
**Bug description**
Heating circuit mode and modetype of Junkers FW200 are reported incorrectly.
**Steps to reproduce**
The problem showed up after upgrading from 2.1.0 ESP8266 to 3.0.0 ESP32.
…
-
got the following values which were discussed above:
```
ems-esp:/# show values
Boiler: Condens 2500/Logamax/Logomatic/Cerapur Top/Greenstar/Generic HT3 (DeviceID:0x08, ProductID:95, Version:34.12)…
-
**Bug description**
For 1st mixer circuit IPM (out of 2 installed) there are missing values for the current and set temperature. The only information
provided is the current pump status. I think thi…
-
Good afternoon.
My heating system has the following equipment:
1. 1 x Junkers CerapurMaxx ZBR 100-3
2. 1 x Gateway MB LAN 2
3. 1 x CW400 Thermostat
4. 7 x MM100 Mixing modules
I use 5 MM100 …
-
**Describe the bug**
There's a 10 second delay on the bot when cancelling orders on Huobi exchange.
**Steps To Reproduce**
1. Run a pure market making bot on Huobi.
2. Set the order refresh …
-
**Bug description**
I'm unable to select a temperature from HA under 20 degrees.
**Steps to reproduce**
Current temp: 20+
Select temp on HA of 19.5 or less
Wait 3 or 4 seconds
The wanted temp…
-
On the ESP8266 and ESP32 I'm seeing the occasional Rx error with the latest v2.
![Capture](https://user-images.githubusercontent.com/1230712/90634594-3987ed00-e228-11ea-9ff1-205ee26d83d7.PNG)
I…