-
Hi,
Everything was working fine until I've divided my network to two subnets: Main and IoT.
For now, I have connection between main and IoT, which means devices in both networks see each other.
Ho…
-
just bought a maxsmart 2.0 and trying to figure out their protocol. as i understand it your reverse engineering is for 1.0 devices, right ? with my 2.0 it seems udp is used too but I haven't been abl…
-
Hello and thanks for the new Makerhub !!!
i want to use Makerhub on a SBC (rock pi 3c) because it can control spindle on/off with GPIO (as with 1.1.2 version of makerverse)
I tried to install on d…
-
I have been trying to do the initial setup of my homebridge with this plugin. After I authenticated to Amazon I get the an error message that simply says HttpError with a reason of no body. Below is …
-
Hi, I recently got Nedis camera (WIFICO11CWT), and I was not able to make it broadcast any dpids by itself.
tinytuya was simply saying "no response". All I could see were reponses to the setting chan…
-
### What happened?
Device: https://www.zigbee2mqtt.io/devices/AB3257001NJ.html
If I switch ON or OFF the device using the physical button, Z2M doesn't update the state.
Pressing the state upd…
-
Hey,
if I use the button on the Osram Smart+ Plug to turn it off or on the state does not change in the gateway. Toggling it from the gateway still works, but it's in a reversed state (for example …
F4bsi updated
4 years ago
-
Would be nice like in the verisure app to see the state of the lock. If autolock is enabled or not.
-
So i'm trying to get some data from my ecoflow powerkit. And after much trial and error i thought i got it working. But still no data coming in so checked the log and saw this?! I dont know why? Maybe…
-
Hi,
first, finaly a smart home gateway that supports more general units than other smart home gateways.
I run on a Raspberry PI 4B with ConBee II USB
After startup (or enable Zigbee plugin) i…