-
I have bricked my board due to using a corrupted TFcard.
Please provide a stock firmware for Robin E3 board which includes a **_bootloader_**,
so that i can reprogram the STM32 chipset via ST-Link V…
-
Hi, is anyone working on or planning to work on Cortex-M33 support? Given it's Cortex-M4 + extras, maybe the necessary adjustments aren't huge. There's for instance a nice "LPC55S69-EVK: LPCXpresso55S…
-
just a short contribution to confirm that I tested these configurations with a ST-LINK V2 (chinese clone) and they are working correctly.
Each time I read eeprom (all zeroes), executed a program to f…
-
```
Running `probe-run --chip nRF52840_xxAA --defmt --input target/thumbv7em-none-eabi/release/device_gwc --probe '0483:3748:C2xxxx' --connect-under-reset`
Error: An error with the usage of the…
-
Ralim, although you closed this problem, it remained for me. Not a single firmware is loaded on the soldering iron, except for the Chinese stock 2.20, including your 2.16. after downloading and copyin…
PUF52 updated
2 years ago
-
Hello,
I am trying to read the flash of an STM8L101F2P3 (`stm8l101?2` from a stm8flash point-of-view) via stlinkv3 without any success.
I built the tool with `DEBUG=1` and it always goes into erro…
-
Hello, thank you for your great project.
But is possible to support the ATSAMR34 ?
Thank You
-
**Describe the bug**
I'm using a ST-Link v2.1 with an ATSAMD21, this combination has been working fine for a few weeks with probe-run and defmt. The first time I do `probe-run --verbose --chip ATSAM…
-
need to get SWO debug output working
see ITM_SendChar
Reported by: rusefi
-
Hello there, thank you for this great alternative to BLHeli! I hope it will replace BLHeli soon :)
I wanna flash my iFlight 4in1 ESCs with AM32. I already bought a STLinkv2 and tried to connect wit…