-
The default PID parameters are assigned around https://github.com/Traumflug/Teacup_Firmware/blob/master/heater.c#L79 it might be nicer to move these out to config.h, or use some optional overrides li…
drf5n updated
7 years ago
-
**Topic**
How hard would it be to redo the UI using [charm.sh](https://charm.sh) libraries?
> NOTE: I have no affiliation with them
This is [soft-serve](https://github.com/charmbracelet/soft-se…
-
_argh_ Yet another branch. Couldn't hold me back, though.
The goal is to get rid of TemperatureTable.h in favour of adding these parameters in config.h. No precomputed table, just the parameters.
So…
-
Storing these four 32-bit values for almost nothing always bugged me, so let's take the plunge and remove them entirely.
These values were introduced together with lookahead. However, lookahead cod…
-
![girl](https://github.com/willaqimeng/willaqimeng.github.io/assets/71533440/2b94fefb-d5fe-4bd9-83a2-f9b1f8fa1aea)
![IMG_7731](https://github.com/willaqimeng/willaqimeng.github.io/assets/71533440/f34…
-
### _title_
Titans' Truce: A Tea Party Tale
### _temperature_
0.06
### _prompt_
Write a story of how Godzilla and King Kong had a tea party.
It must have reference to all their movie's trivia.
### …
-
My setup is: Tiertime Up Mini printer electronics and mechanics, but the controller is replaced by an Arduino Nano (yes only an Atmega 328P). I am at a point where it is possible to home the printer…
-
**Describe the feature**
### The Problem
Nat Pryce once [described](http://www.natpryce.com/articles/000714.html) such a pattern as Test Data Builder. When I once wrote an [article](https://blog.a…
-
I notice that when the printer is homing via G28, as it is moving on the X, Y, and then Z axes, the extruder gear is turning. Not very fast, but turning none the less.
-
It escaped me for a while, somebody pushed code for I2C display support to the repo recently. Thank you for this!
Now, the unfortunate thing is, judging by the commit messages it apparently doesn't w…