-
### Description
- Type: Bug?
With seven or more clients connected to the mbed Device Connector some of them are not listed temporally or disappear until I reset the client.
We are using mbed-os…
-
I always get Low Down PRR value when I test 6lbr with CC1310. For Up PRR, I can get 100% but it's 4.3% on Down PRR. Is this normal? Doesn't higher value in Down PRR means better delivery rate?
-
We are not able to ping global IPv6 addresses from a mesh network.
Our system setup is as follows:
- a mbed 6LoWPAN Border Router HAT connected to mbed-access-point
- mbed-access-point (using pre-co…
-
I apologize if this is a FAQ, I'm searching through the mail archives now, too, but so far I haven't found a solution to my problem.
I'm trying to bring up 6lbr on my BeagleBone Black with a TI CC253…
-
Hi everybody:
In my project i configured the next architecture:
CC2650STK(CC26xx-web-demo) CC2650STK(Slip-radio) Raspberry Pi2 (Router with IP64) External Server on windows(Mosquitto Broker) …
-
Hi,
I am currently stuck with a problem similar to the one discussed in #153 and a little help would be a real godsend!
I am using a couple of SmartRF modules plugged via USB on two different Linux …
-
I have been using 6lbr for couple months without any problem, but somehow it stopped routing udp packets to the sensor network (aaaa::/64) . I am able to receive UDP packets from the contiki nodes.
I…
-
Logging failures when application was build:
mbed compile -m NUCLEO_F411RE -t GCC_ARM --app-config configs/mesh_6lowpan.json
Log "pins not configured correctly" comes every time.
I restarted me…
-
Hi,
I have a problem to configure the Border router on an IPv4 network with an IPv6 tunnel.
I already tried the client exemple and its working with the Firefly border-router on an **IPV6 network**…
ghost updated
7 years ago
-
The original problem reported isn't a bug any where but is still a problem. If two border-routers are within range, the can add each other as the default route which causes the fallback interface to f…