-
Requesting support for Kamstrup Omnipower HAN-module and Aidon AMI system smart meters with "HAN-NVE" RJ45 interface.
"HAN-NVE" has a physical RJ45 port which in Sweden and Scandinavia is referred …
Hedda updated
2 years ago
-
Crash after flashing using bin file and compiling latest source.
**Relevant firmware information:**
- Version: 2.0.1 and 2.0.2. Version 2.0.0 is ok
- MQTT: yes
- AMS reader: Kamstrup module b…
-
Requesting support for Kamstrup Omnipower HAN-module and Aidon AMI system smart meters with "HAN-NVE" RJ45 interface.
"HAN-NVE" has a physical RJ45 port which in Sweden and Scandinavia is referred …
Hedda updated
2 years ago
-
Hi
My D1 mini board seems to work fine with the setup.
I have add the encryptions.
When I connect the setup to my Meter then first "HAN" is green, then change to Orange and then change to RED.
…
-
When the clock or Device ID with obis code below are not pushed from the smart meter because they are configured not to push them (depends on the standard CII configuration of each DSO), the dlms pars…
-
In one of my tests, I have a DLMS server (over TCP) which responds slowly. This results in the following error message:
Traceback (most recent call last):
File "", line 1, in
File "C:\Program …
-
Hey @gskjold
I have an issue where the data is not shown using my Danish Kamstrup Omnipower meter running on POW-K from @ArnieO. The HAN module is just red.
Here is a dump from the log
```
…
-
Have been struggling a bit with my brand new Sagemcom T211 (with the P1 interface activated). Don't know if it's the meter that is not supported or anything else (I'm not a programmer).
**lsusb** …
-
I am currently writing new code to interpret data from the meter. The new firmware should support any IEC62056-7-5 (Norwegian and Danish meters with HDLC payload) and IEC62056-21 (Swedish and possibly…
-
På marknaden verkar just nu de flesta tillverkare av smart hemutrustning använda rj45 för att ansluta till elmätaren. Men samtidigt har många mätare rj11 eller rj12. Skulle ni säga att det är möjligt …