-
it is possible to choose between a DS18B20 or a DHT22 on the GPIO connection. In addition to the temperature, you can also measure the humidity in the room. That would be great.
-
Board: Arduino Mega 2560 R3 (original)
J5 version: 1.4.0
Node.js version: 12.16.1
In my project, I need a lot of thermometers and facing an issue when trying to read more than two sensors. It doe…
-
Hallo
Vielen Dank dass Du deinen Code zur Verfügung stellst !!!
Ich hätte noch zwei Erweiterungswünsche:
RTC Modul (DS3231) integrieren (Da ich leider in meinem Hobby Raum kein WIFI habe)
ds…
-
I use OH240 with this:
https://janessa.me/esh/org.openhab.binding.onewire-MASTER.jar
265 │ Active │ 80 │ 2.5.0.201903031011 │ OneWire Binding
I get:
OFFLINE - CONFIGURATION_ERROR required…
-
Even though the `ONEWIRE_PRESENCE_TIME_MIN` is set to **160_us** (and the comment right next to it says "_was 125 us_" to confuse reader a bit) it actually generates **pulse more than 272 us long** (w…
-
This issue is still a timing logic problem.
My code is as follows:
```
#include
#include
#define ONE_WIRE_BUS 2
OneWire oneWire(ONE_WIRE_BUS);
DallasTemperature sensors(&oneWire);
vo…
-
I'm trying to run this program on raspberry pi (kernel 4.1.14) but in never prints anything. Debuging with gdb shows that it stays on poll forever. I have 2 DS18B20 on gpio 17 and from /sys/bus/w1/dev…
-
**Describe the bug**
Once a temperature alarm is setup as input display of temperature sensors in enclosure tab is not working for any sensor. Also the set up alarm does not trigger.
**To Reproduc…
fbbln updated
3 years ago
-
### The problem
First of all thanks for all the great work, and for bringing Raspberry Pi Pico support!
Just tried it for the first time and I can get the Pico up and running fine, but hitting an …
-
Hello!
I'm using the onewire CI DS28E05 (https://datasheets.maximintegrated.com/en/ds/DS28E05.pdf) but Micropython `ow.scan()` show nothing. That is a `onewire` chip, so it use/works with the `on…