-
Board|MCU|State|To-Do
-|-|-|-
8-Bit AVR boards, RAMPS, etc.|Arduino AVR|đź’šgood|
Due, RAMPS FD (v2.A!), etc.|SAM3X8E|💚good|
Duet Wifi + X5|SAM3X8E|âť“unknown|E3D Toolchanger on hand
Duet 2 Maestro|SA…
-
information the title doesnt have. I have a Iflight succex F4-e flight controller. A rxsr receiver and a qx7s radio. flight controller and receiver wired for Fport, betaflight configured for Fport. I …
-
Steps to reproduce the behavior:
I crashed when I went to re-arm and one of the motors instantly went up in smoke, while the other 3 motors twitched. The ESC is fine and I replaced the motor but th…
-
I followed Oscarlang Guide (https://oscarliang.com/setup-r9m-r9-mini-betaflight/) and everything looks good (binding, betaflight sticks \ aux working) but no telemetry in the openTX except for RSSI. …
-
![sfxzLt3](https://user-images.githubusercontent.com/56779610/67154528-03bf6280-f2fe-11e9-9834-147a13f29f0e.jpg)
I followed Oscarlang Guide (https://oscarliang.com/setup-r9m-r9-mini-betaflight/) an…
-
I have here a pikof4 with innova v4 vtx combo, and with 3.1.7 firmware, then MSP with the True vision app is working
Uart 1 MSP 115200 activated
When i flash a diffrent firmware then the connectio…
-
When I hold the controller steadily, it registers micromovements that result in camera jitter while aiming in BotW on Z axis. Even if I place the controller on a flat surface, it still jitters for 5 s…
-
I build with Matek F722-SE.
Up the throttle and the drone jump and spin.
Betaflight firmware : 4.0.6
video : https://youtu.be/OI60AGEmyws
Below is the dump file
----------------------------…
-
Flashed BF 4.0 #1199 on a Matek F722 FC and a Flip32 Omnibus FC. Last known good flights with no issues were on 3.5.0 RC2. On #1199 both fly great and I was interested in seeing how the dynamic LPF wo…
-
Hello I'm Nick,
i have a problem with mit JB4 with the 4 in1 ESCs. I did calibrate the ESCs and thought I check every settings double, but the Motors are begin to rotate more and more after i push …