-
`sanitycheck -p frdm_k82f -T samples/drivers/spi_fujitsu_fram` fails on master, blocking successful shippable in #21776.
```
/mnt/nordic/zp/zephyr/samples/drivers/spi_fujitsu_fram/src/main.c: In…
-
Hi!
I was sad to see that the Adafruit I2C FRAM breakout wasn't compatible with the Feather M0 (as indicated in the compatibility chart). However, I still tried it out just to see how it bad things b…
-
I was just playing around (mainly to add the Neopixel library) and by mistake added the `i2c-fram` package to my project. Site complained and locked up, so I refreshed and ended up being presented wit…
-
I would like to see direct FRAM support... eliminating the un-needed read/verify command after a write with FRAM's...
thanks
-
Hi,
As I understand it, the adafruit library writes arrays inefficiently because it takes 4 bytes to write a single byte: https://arduino.stackexchange.com/questions/44082/i2c-fram-read-write-is-ve…
-
- [x] add search button in 'add package' - otherwise GH throttles us too hard
- [x] support pasting URLs in search: `https://github.com/mmoskal/pxt-i2c-fram`, `mmoskal/pxt-i2c-fram`, `mmoskal/pxt-i2c-…
-
I am using
esp32 ttgo sim 800l (https://rb.gy/ogywnq)
Dfrobot dht22 (https://www.dfrobot.com/product-1102.html)
my code
DHTNEW DHT(18);
DHT.setWaitForReading(true);
```cpp
float DHTtemp…
-
I can add the Neopixel package using More->Add Package.
To remove the package I have to edit the text of Project Settings. This is not intuitive.
FYI, the i2c-fram package fails to load when added, …
-
Greetings,
I'm using the `i2cEeprom` module to read and write data to a FM24CL64 FRAM chip. The firmware is running on a STM32F042K6 chip.
Reading data from the FRAM works without any problems but…
nesos updated
5 years ago
-
I need to arrange a 1 mS timer to call enet_proc_input and enet_poll(). I looked at using driver_delay_ms but that seems like more overhead than necessary. Is there a better way to do that?
From th…