-
Any photos or description of how you mounted the motor to your lead screw and what motor / driver you are using?
I have the same lathe, and have enough spare steppers/servos, ESP boards to build th…
-
Hello terjeio,
today i did some short probing tests and would like to tell you the results.
First of all I would like to suggest that you can jogging in the probing tab, would be very helpful in m…
-
I am currently in the process of migrating my CentOS 7-based Jool 3.5.7 configuration to Jool 4.
My kernel release is 3.10.0-1127.el7.x86_64.
I am configuring Jool using atomic configuration; my…
-
**Description**
Hello ! I'm using the 3rd serial console and I send command using the fields "G-code generation>G-code Header/G-code footer" and "Clipping>G-code before tile". The commands work, …
-
My setup must have a bit of electrical noise- I have had a few cases where the thread pitch setting changed on its own, or it switched from threading mode to feed mode. It is intermittent, but only se…
-
Are you able to share the nextion editor configuration?
-
So i am looking to add encoder support to my mill and was shopping around but before buy i had a few questions.
What would be the max supported PPR (pulse per rev) of the hardware.(skr 1.4 non turbo…
-
Has anyone converted the Harbor-Freight 7x14, SIEG style lathes and have documentation on it as to the steps you took?
-
I am not sure the best way to do this. If this is wrong, please point me in the right direction. I know it isn't a traditional github "issue".
I feel that having lots of good quality BreakOut Board…
-
So i continue the thread to this new issue. After thegreat help i received i managed to make the motor run. Now the problem is that it turns on one direction only cw and when rotating the encoder anti…