-
I have idea for new configuration options for meters.
1) initial value
2) invert direction
1) For me it can be used for old used water meters, that have initial value of some value i.e. m3 o…
-
Hello all, i am guessing my values are a bit off with the infinite decimals i got :P could someone please help me out
This is my output:
```
4526402
AMT
128
…
-
The HAN-port is located top left and the module is installed by pushing it in. There is a DIN-variant that has the HAN-port located to the left.
![Kamstrup_OMNIPOWER_3_phase](https://user-images.gi…
-
Hello.
Does this work with this https://www.az-delivery.de/products/esp32-developmentboard?
In the readme it said that the GPIO36 from the esp32 need to be connected with TX from M-Bus Board, but th…
-
Since several releases there is a too large firmware shipped. ( Iooked into the last 5 releases)
```
E.G: I see:
-rw-r--r-- 1 aj aj 73K Mär 30 2017 CUL_V3_433MHZ.hex
-rw-r--r-- 1 aj aj 80K Mä…
-
Ich habe leider bei einem Netz NÖ Kaifa Zähler ein Problem.
1) Scheint das Timing hier etwas langsamer zu sein, die Pause zwischen erstem und zweitem Datensatz sind ca. 160ms:
![grafik](https://…
-
I've been trying to get Minemeld running on a different distro without much success. I have compiled the latest version without problems, but can't get it to run.
I see that the published Docker con…
-
... see https://github.com/Apollon77/smartmeter-obis/issues/4#issuecomment-568581511 ... as I understand in fact wmbus and OMS is kind of very near to each other or?!
-
**Impact**: rtl | software | unknown | other
**Description**
**What is a motivating example for changing the behavior?**
Hi,
`QSFP1VCU118PlacedOverlay` and `QSFP2VCU118PlacedOverlay` hav…
-
basically, any serious PCIe activity seems to be hanging the system. Most of the time it's a hard lockup (no sysrq, the HW debugger says the cores are around 0xffff0000), a few times sysrq was still w…