-
I thought I would get even data, but it turns out I can get odd data too.
how it can be happened?
-
Hi,
the automatic calibration procedure is quite nice - at least it is much simpler than any manual calibration would be. However results are somewhat underwhelming: Most of the time my DIY-thermoc…
-
Hi. Is there a trick to getting this to work over I2C, vice SMBUS? What could cause it to work on Raspberry Pi, but not STM32? I've tried F3 and L4, with no luck, but it works on Pi using this drive. …
-
In Raspberry Pi 3B+ with Raspbian.
When I use **UnixI2cDevice.WriteRead()**, the program random throw **System.IO.IOException: Error performing I2c data transfer**. Sometimes 10 calls occur, and so…
-
Hello,
I can't install the firmware for the fist time in the camera. I have just assembled it all and so I want to flash the firmware.
With the updater from the software folder, and the last HEX…
-
When I was trying to interface a I2C Sensor with a AVR128DA48 it didn't work. After some debugging I found the two problems in the twi.c file:
1. When changing the clock, the TWI Master is disabled a…
-
Hi
this:
```
void exitPWM(void)
{
// Make SMBus request to force SMBus output instead of PWM
SoftWire::setSclLow(&i2c);
delay(3); // Must be > 1.44ms
SoftWire::setSclHigh(&i2c);
delay(2)…
-
Hi, first the class SoftWire no longer has set, I mean setSclHigh, setSclLow and so on.
They changed to only the signal name without the "set", like for example sclHigh, sclLow...
Second the examp…
-
Hello,
So I'm using a trinket m0 and a MLX90614 with a breakout.
SDA from sensor connected to SDA trinket m0
SCL from sensor connected to SCL trinket m0
GND from sensor connected to GND trinket …
-
**Is your feature request related to a problem? Please describe.**
I know that use of radiant heat panels is common among people who keep reptiles. Personally I've just recently branched into them my…