-
Hi Team
I cloned your repository and successfully compiled your code on the vivado.
But when I take the source file "TDCServer2.c" to compile in SDK 2018.2, there are mismatches of include files …
-
### Description of the setup:
* Device: STEMLAB 125-14 4-input
* SD card image: Latest Beta 2.0 (2.00-23)
* Application: MCPHA
* *Relevant information: The red pitaya is connected direct…
cztee updated
9 months ago
-
### Description of the setup:
* Device: 122-16
* SD card image: Factory image or your custom image
* Application: Partial reconfiguration for a research project
* Other relevant informat…
-
Hi,
I am trying to use my device for data acquisition. I need to acquire samples from RF-IN1 by 2 minutes with a 256 decimation factor (around 60 mln samples). I suppose that Deep Memory Acquisition …
-
Amp control board (D4) creates 2.3 kHz audible tone when powered up. 12VDC, 8x "small coil" dummy loads connected, draws 430 mA instead of expected 300 mA idle.
- Can see minor 2.3 kHz spikes on E…
-
I tried using LIAControl.jar to write the lock-in data onto a file on the host PC.
When I apply the modulation voltage (0.5V) and constant sweep of 0V, and sweep setting (-0.95V to 0.95V over 5s),…
-
As suggested by @doronbehar in https://github.com/doronbehar)https://github.com/linien-org/linien/pull/277#issuecomment-1272506334.
-
How to easily ensure reading and writing of several devices on the i2c bus.
I connected MCP23008 and LTC1380.
With MCP I can only read once. LTC1380 is not detected yet.
https://github.com/karu20…
-
Any experiment that takes longer than the pyro timeout defined in devices/executorDevices.py initialize(), current main branch has this as 6 seconds, will truncate the experiment with a pyro timeout e…
-
Hello!
It's impossible to generate hpsdr receiver bitstream for this FPGA just using approach like for building bitstream for hpsdr transceiver (_make NAME=sdr_transceiver_hpsdr_122_88 bit_) becaus…