-
### The problem
After having completed some test with SCD30 on ESP32 I started to dig into more adventurous use cases such as lowering the power usage. I wanted to use the SCD30's RDY pin, but after …
-
I keep getting "Not enough data received" error when I execute a forced recalibration. I believe it's because the wrong number of bytes is expected in a the response. The library expects 5 but the r…
-
Different sensors read data at different times and with different intervals. It would be convenient for the frontend to receive all values at once, with the same step number and timestamp. In order …
-
Both sensors are connected through the i2c connection. TTGO TDisplay. Firmware rev851
The device only detects the SCD30 sensor.
The SCD30 sensor is disconnected (unplugged) and after a reset the…
-
Hi,
I just finished your instructions. I have an ESP8266 board, a Seeed SCD30 and a 3V piezo speaker. I had to download and integrate almost all of the libraries as zips because they were not found…
-
Hi,
I am going to create a new device in Iot.Device.Bindings and make a pull request.
However, I am worried about conflict with other developers.
Is there a mechanism for communicating in advance?
-
- Arduino board: **INSERT ARDUINO BOARD NAME/TYPE HERE**
- Adafruit ESP32 Huzzah
- Adafruit SCD30
- **INSERT ARDUINOVERSION HERE**
- 1.8.13
- List the steps to reproduce the problem below (i…
-
Hi @smuellerDD, Please forgive maybe the mistake of opening an issue here.
I am stuck on GRUB boot after I enable LRNG on OpenWrt x86_64 Linux 6.1.47.
LRNG Version: v50
Patch Files: https://git…
-
My setup is:
TTGO T-Display
Sensirion SPS30
Sensirion SCD30
On the graf i the app only CO2 shows value PM,Temp and Humidity shows zero
-
Many thanks for the script - works out of the box! I have ordered a book on MicroPython from Elector to gain more insight into Micropython. While I have been able to trigger a relay using the built-in…