-
### Description
I've just installed the Firmware 2.0.6 for Z homing on the e3 mini of my ender 3 pro and the bed leveling fails running outside of the bed.
Another issue I found is the Z Axis b…
-
### Description
The board does NOT accept any "firmware.bin" and just refuse to boot when one is inserted in the SD card reader
### Steps to reproduce
1. compile a "firmware.bin" or download on…
-
I have been able to flash the firmware and nothing works. it will turn on and stay on the boot screen. I have the ski mini e3 v3 .
-
Running into an issue with the new Sprite extruder with my BL touch. The much further forward mount is positioning the sensor off the build plate during the auto level feature.
Is there a firwar…
-
### Is there an existing issue for this problem?
- [X] I have searched the existing issues
### OrcaSlicer Version
2.2.0-rc
### Operating System (OS)
Linux
### OS Version
Arch Linux (everything …
-
### Description
Replaced the stock Creality board with the SKR mini E3 v2.0 on my Ender 5.
After the install used the firmware for Ender 5 (https://github.com/bigtreetech/BIGTREETECH-SKR-mini-E3/blo…
-
My newly installed SKR mini E3 will not recognized any micro sd card installed. I've rebooted, reset, re-format the micro sd card and the TFT35 v3 has no problem reading any of the sd cards and if I c…
-
I have been using OctoLapse for over a year with Cura and it works fine w/ manual settings. I recently switched to PrusaSlicer and set up OctoLapse according to the wiki. The printer is Ender 3 w/ Mic…
-
**Describe the bug**
**To Reproduce**
Sending a "[ESP700]/SD/test.gcode" in web gui terminal gives me:
> [ESP700]/SD/test.gcode
> ok
> error: stream failed: 1
**Expected behavior**
no error…
-
Old information, scroll down to the part where the EEPROM causes issues.
```
> Executing task in folder Marlin-2.0.x-SKR-Mini-E3-V1.2: C:\Users\Philippe\.platformio\penv\Scripts\platformio.exe run…