-
Fantastic little write up, just wanted to say thank you for taking the time to mess with it. Also curious to know if any more interesting progress has been made on the app/code. Been dying to build so…
-
M569.4 will let us configure a speedlimit for closed loop stepper motors opperated in constant torque mode. It would be nice if a driver- warning event is raised when this happens. This would allow us…
-
thank you for making this library and found your post on reddit!
I want to know how fast(maximum fast say for a 1.2A stepper motor with a4988 driver) and minimum rpm (slowest) it can go?
I read yo…
-
I'm using a Sidewinder X1 and Repetier Server!
Before installing the S42B there was no problem to change the filament during a print.
When I hit PAUSE the nozzle would raise 5mm and X/Y would home! …
-
I'm sorry for my bad title but I couldn't think of a better one.
I am using StepperOnline DM860T drivers connected to a GRBL controller.
Previously I used cheap TB6600 drivers which worked instant…
-
The MMU produces quite a hissing sound while idle.
The stepper drivers should enter a reduced power mode while not moving.
-
Hello everybody,I have a problem with my delta printer and I would be very grateful if you help me
to solve it.
I'm using Arduino due + RADDS with Repetier firmware.
The problem started when the …
mj996 updated
4 years ago
-
Hi, I am trying to use the PicoCNC board with the RP2040 for a DIY plasma cutter and am trying to get THC working. The analog input will be the ADC on GPIO28, moving the probe pin to 24. I also ordere…
-
[test Stepper.txt](https://github.com/waspinator/AccelStepper/files/4405305/test.Stepper.txt)
Hi, I'm using the library with a Stepper driver (only use Pulse pin and Dir pin).
I'm running an exa…
-
Hi,
I've purchased the TMC2226 drivers to upgrade my BIQU B1 and would like to know if I just need to replace the original stepper drivers or do I need to change the firmware to work with the new d…