-
Hi
I installed a BL Touch (from Antclabs) and the Micro Swiss Direct Drive Extruder Setup. Now i need to change the #define X_MIN_POS and #define Y_MIN_POS to #define X_MIN_POS -5 and #define Y_MIN_P…
-
Hi everyone,
I'm trying to create a custom board that is based on a Nucleo-144. I want to have this board versioned so I simply copied the directory `boads/arm/stm32f7/nucleo-144` to my repository.…
-
It seems there is no support for STM32H5 yet. Is it currently being worked on ? If not, and if I can, I am considering to add it with the board nucleo-stm32h563zi. I see there is an stm32 folder and…
-
When calling `puts/printf` after `thread_create()`, the CPU hangs. This seems to be connected to the mutex used in the uart driver for syncing the DMA transfer in `uart_write()`. When disabling DMA fo…
-
I am unable to connect to STM32F767ZG
```
Open On-Chip Debugger 0.12.0-00017-gb153daa14 (2023-02-03-14:58) [https://github.com/STMicroelectronics/OpenOCD]
Licensed under GNU GPL v2
For bug repo…
-
``` rust
interrupt::disable();
let mut p = defmt::unwrap!(cortex_m::Peripherals::take());
p.DCB.enable_trace();
p.DWT.enable_cycle_counter();
let start = DWT::get_cycle_count();
cortex_m::asm::d…
-
### FileNotFoundError:
When I try to compile I get the following error?
`> Executing task: C:\Users\r_vei\.platformio\penv\Scripts\platformio.exe run --environment STM32F103RC_btt_512K <…
-
I've been trying for 2 days to recompile other folks firmware and also tried editing the stock marlin 2 software to no avail. I am using VSC and Platformio and I have no experience with this kind of s…
-
Rarely (three times in last two days of heavy use) I've had my stm32f765 board lock up during startup (after reset, not cold power on).
This occurs while trying to read a file from working filesyst…
-
I have tried to compile the new firmware as I need to change the BLTouch offsets in relation to the nozzle as I have a non-standard setup. I've downloaded and extracted the firmware made the changes f…