-
Hello, we are about to release a new i/o board that includes among all other chips already supported by Tasmota mcp4725 for dual or quad 0-10v output ( mainly for valves, dimmers, fan with 0-10v…
-
I have a OSH xPRO v5and its set up on a Queenbee 1500x1500mm system. At first everything would work, but sporadically Y would not Home. After Z and x home normally Y just jumps 3mm in the positive dir…
-
## The problem
I recently bought a Sonoff ZB Bridge, flashed with Tasmota and using with with ZHA in Home Assistant. The problem I'm experiencing is that all my connected zigbee devices report Powe…
-
I noticed when I loaded this configuration and attempted to run it I got an error
Unknown line "ppt"
I removed that line from the file and the axis came up.
Also the documentation says to flash…
-
Hi, I posted this [(MKS)](https://github.com/cprezzi/grbl-LPC/issues/22) a few minutes back then found this forum.
Can someone please assist me with this.
Is the TTL with pin 1.23 option locked …
-
Is this still being monitored?
I have a very old Synrad 25w laser that is working fine, but the supporting electronics are toast. I have an MKS-SBASE board from a printer and have installed grbl-LP…
-
## Mycodo Feature Request:
- Specific Mycodo Version:7.78
Request a slide bar type output control.
Reason: Want to use it for a light dimmer.
-
Hallo,
I try to simulate a sunrise end sunset by dimming a T5 Lamp.
what do I have to set, to make the following states (0% light till 100% light)
08:00 am: switch on Relais and raise PWM Dimmer …
-
i need urgent help on tabula automation. i read your article at the below link but and installed pip as well as tabula-py image below -
https://github.com/chezou/tabula-py
But how to proceed a…
-
When the configuration of the MKR1000 is on Access Point with WEP security some devices connect and get the IP from DHCP, other devices not.
If I change the AP with no security every devices connect a…