-
### The problem
Release 2024.7.3, Dallas_temp on ESP32 gets "Scratch pad checksum invalid!" Works fine in 2024.6.6
13:55:05 | [W] | [component:170] | Component dallas_temp.sensor cleared Warning f…
-
My G90B alarm triggers in zones that have been violated and the time is not reported in Home Assistant and I don't know how to have a record of the day and time of violation of the zones.
-
### Checks
- [X] I have searched the bug with a few keywords, and I confirm this bug was not yet reported.
- [X] The round I am reporting the bug from, or I am going to talk about, has already ended.…
-
### Environment
- Build Version: 22032806
- OS Version: Mac_Catalina
Constructed fire alarms (not working) and firelocks duplicating.
We should be able to mount fire alarms to a wall and s…
-
### Describe the bug
I have suspected that my Time nodes are sending multiple messages for a while. I use Time Nodes in a few places. One is to start automations each morning for our alarms to wake u…
-
Hi again Lance!
I was able to access one-wire-on-fire.org via a VPN connection in the USA and download the archive. I have it in place and reconfigured permissions so that it works. Temperature senso…
-
Bonjour,
désolé de passer par ce moyen pour demander de l'aide, mais je ne trouve aucun autre moyen.
J'ai tenté l'installation sur Jeedom : Version : 4.3.15, Branche : V4-stable , Système : RPI …
-
To make the hypnos power rail control easier, an enum system was implemented. This should be tested with different configurations of enabling/ disabling the power rails. These changes are on the lates…
-
Just installed limit switches on a 3018pro and I can't get the z axis to home. The switch works and is Normally Open . If I press any of the other switches on different axis the up movement stops as…
-
Problem: I want to set up a homing cycle for my CNC machine and to do so I placed pairs of limit switches at both ends of all my axes, X, Y, and Z. Then I wired them in the suggested NC configuration.…