-
I have a new attiny404 which I've tried programming with both a HV UPDI programmer and a DIY/arduino version, but both encounter the same error message: `avrdude error: bad response to read memory com…
-
I am not so sure how difficult it is to add the support of mega0 AVR and Tiny0/1/2 AVR, similar to optiboot_x.
Stretch goal will be to add the support of AVR DA/DB/DD part, similar to optiboot_dx.
…
-
I wanted to read via a Intterupt a multiplexed signal from an RC-Receiver (Robbe) and take the value and set it to a servo connected.
Both pices working great if they are not used together. As soon…
-
Hello, I'm trying to compile `etherparse` 0.14.2 in a `no_std` crate but im getting errors about `add_2bytes` (among others) not existing.
```
cargo build
Compiling etherparse v0.14.2
error[E…
-
(Downstream issue: Rahix/avr-hal#388)
A bug was introduced in #103240 (5642a751ecc76fff232351f5686d49475fb06a09) when compiling for AVR targets, causing errors in linking which look like:
```
e…
-
The current "avrdude.conf" has the following description in three places: ".xmega", ".avr8x", and ".avrdx".
```
memory "data"
# SRAM, only used to supply the offset
offset …
-
Hello!
I'm pretty new to cross-compiling.
I created a nix environment in which i can compile the .ELF file for some targets.
For example, the target avr-atmega328p.json works:
```
bash-5.1$…
-
Normally fuse bits are defined like
```
#define FUSE_SOMETHING (unsigned char)~_BV(some_n)
```
For the list of parts below gcc v12 defines a lot of them *without bit inversion* `~`
```
atmega1…
-
Hi,
your lib looks very promising. Unfortunately there are big problems with it. If I use it with Arduino then the controller always resets.
If I use it in Atmel Studio 7 it always compiles with…
-
### Discussed in https://github.com/SpenceKonde/megaTinyCore/discussions/902
Originally posted by **PaulEast** January 26, 2023
Good morning everyone, firstly I'm in awe of this development an…