-
I used the `LoRa Receiver Callback` example and changed only the operating frequency and pins using `setPins` shown in the code below. I connected `DIO0` to pin `PA3`/`PCINT3`, `SS` to `PA0`/`PCINT0` …
-
Tested with v1.1.5 of https://github.com/SpenceKonde/ATTinyCore
Arduino Uno works with level converters
Attiny85 works when using 3.3v and 5v w/ level converter.
Attiny84 and Attiny841 do not …
-
I ordered a small run of your Cing ultrasonic printed circuit boards from:
https://www.pcbway.com/project/shareproject/I2C_Ultrasonic_sensor_with_compensation.html
The silkscreen shows parts place…
-
Does your library support SPI in master or slave mode for Attiny84?
-
```
What steps will reproduce the problem?
1. Unpack\install arduino-1.0.1-windows.zip
2. copy Timer1 library to \arduino-1.0.1\libraries
3. Start Arduino IDE, load ISRBlink example sketch and verify…
-
```
What steps will reproduce the problem?
1. Unpack\install arduino-1.0.1-windows.zip
2. copy Timer1 library to \arduino-1.0.1\libraries
3. Start Arduino IDE, load ISRBlink example sketch and verify…
-
```
What steps will reproduce the problem?
1. Unpack\install arduino-1.0.1-windows.zip
2. copy Timer1 library to \arduino-1.0.1\libraries
3. Start Arduino IDE, load ISRBlink example sketch and verify…
-
```
What steps will reproduce the problem?
1. Unpack\install arduino-1.0.1-windows.zip
2. copy Timer1 library to \arduino-1.0.1\libraries
3. Start Arduino IDE, load ISRBlink example sketch and verify…
-
```
What steps will reproduce the problem?
1. Unpack\install arduino-1.0.1-windows.zip
2. copy Timer1 library to \arduino-1.0.1\libraries
3. Start Arduino IDE, load ISRBlink example sketch and verify…
-
```
What steps will reproduce the problem?
1. Unpack\install arduino-1.0.1-windows.zip
2. copy Timer1 library to \arduino-1.0.1\libraries
3. Start Arduino IDE, load ISRBlink example sketch and verify…