-
It appears to be impossible to turn off the power LED on v1.1 of the Core2. M5.Power.setLed(0) works fine on v1.0 of Core2, but it doesn't seem to work on v1.1.
It's definitely possible to turn off…
-
New T-Beam V1.2 has replaced PMU
There is no AXP192 but AXP2101
Please add support for that chip, probably migration to [XPowersLib](https://github.com/lewisxhe/XPowersLib) is needed.
https:/…
-
When attached to the serial monitor, the logs are flooded with a print buffer deprecation error, here is an example of the logs from boot (DevEUI, AppEUI, AppKey & location redacted):
```
rst:0x1 (P…
-
Hello,
I have a TBeam-AXP2101-V1.2 and unfortunately, the current AXP implementation doesn't work. (Indeed, AXP2101 is NOT AXP192).
I have found library XPowersLib (https://github.com/lewisxhe/XPo…
-
[AXP192 Datasheet v1.13_cn.pdf](https://github.com/Xinyuan-LilyGO/LilyGo-T-PCIE/files/12102488/AXP192.Datasheet.v1.13_cn.pdf)
In section 9.6 of this datasheet (9.6 默认电压/启动时序的设置(Default Voltage/Timing…
-
Kindly consider adding support for TTGO T-Beam v1.2 with SX1276 for 915 MHz.
I was able to get it working with the following diffs.
platformio.ini had sections for TTGO_T_Beam_V1_2 and TTGO_T_Beam_V…
-
### The problem
When I add the CAM32 component to my board yaml (see below) I get into a bootloop. Loggings can be found below.
Using the SSD1306 display which is also on the board without the camer…
-
Dear Christian,
I try to flash some of the new T-Beam boards with the new Powerchip.
All boards not working anymore.
They hang up while try to TX.
Any idea whats the issue?
Regards Dan DL6OW
-
I could need some help with LoRa communication between an T-Beam SoftRF SX1626 and a T-Beam Mashtastic. I tried to use the transmitter and receiver code from:
https://github.com/Xinyuan-LilyGO/LilyGo…
-
Hi,
I just installed the latest version from the main branch successfully from with pio (console). Now the start screens shows up, display shows after some seconds LoRa initiated and then switches t…