-
List: https://www.etsy.com/uk/market/standing_desk
https://www.etsy.com/uk/listing/230825862/birch-standstand-standing-desk-and
![standing-desk-existing-products-stand-stand](https://cloud.githubuser…
-
```
I responsen så är relationer ospecificerat vilket ju gör denna svår att
använda. Önskvärt är att denna returnerar relationer med samma innehåll
som Skatteverkets Navet.
En mer allmän fråga är j…
-
Hi,
What does the delay_until do? And why did you use "5" as argument?
Thanks
-
I have followed your example and schematic as perfectly as possible. Quntuple-checking every connection, but the desk never moves. I have switched back and forth to the built-in controller, and it alw…
-
Raising/Lowering a Sit/Standing Desk manually is _lame_ and means someone with reduced mobility (_or strength_) cannot operate it without assistance. (_I have a relative with [MS](https://en.wikipedia…
-
Hi, I'm thinking of using an ESP8266 to control the desk. Its GPIO pin can be set to either 3.3V or 0V.
Can I connect the pin directly to the button? So that I can set the GPIO to 0 to simulate th…
-
```
Add LIN protocol.
Check the Microchip MCP2021 transceiver.
```
Original issue reported on code.google.com by `ianles...@gmail.com` on 31 Mar 2009 at 2:37
-
@trainman419 You did a very good job! I was using two relay to simulate the button but that's just an ugly solution. It's way better to communicate to the LIN bus directly.
Btw, I'm using ESP8266 …
-
Hello,
I flashed my desktop with your firmware. Everything works but if the office down to the bottom, the relay remains active.
Is there a low position memory on your firmware?
From the fact…
-
Hello, do I need to use a LIN transceiver (for example this one http://www.atmel.com/images/atmel-4916-lin-networking-ata6662c_datasheet.pdf ) with your library? I want to generate LIN 2.0 master fra…